Industry Information

Update June 19, 2023

Bolt, High strength bolts, Screw When using two nuts, one thick and one thin, to prevent loosening, the thick nut should be placed on top, and most people use it in the opposite direction. Therefore,...

Update June 17, 2023

Common problems with laser marking machine computers and what to do if the XY axis is not on time

Bolt, High strength bolts, Screw The complexity of the graphics during the processing must be checked. The online computer cannot be connected to the network cable. It can control the laser system...

Update June 16, 2023

What are the precautions for laser marking machines

Bolt, High strength bolts, Screw 1. It is strictly prohibited to start the laser power supply and Q-switching power supply when there is no water or abnormal water circulation; 2. The Q power supply...

Update June 15, 2023

What should I do if I encounter a situation where the laser marking machine cannot cut through

Bolt, High strength bolts, Screw There are various reasons for problems, and the following are some troubleshooting methods: If the vertical light is not correct, it is necessary to adjust the...

Update June 14, 2023

What is the reason why the laser marking machine does not emit light

Bolt, High strength bolts, Screw There are several reasons and solutions 1. The light path screws of the entire machine are loose and need to be tightened. 2. Is there too much dust inside the gun...

Update June 13, 2023

What if the intensity of the laser marking machine decreases and the marking is not clear

Bolt, High strength bolts, Screw Fault: Laser intensity reduced, marking not clear enough Solution: Whether the laser resonant cavity has changed; Fine tune the resonant cavity lens. It is best to...

Update June 12, 2023

How does a milling machine perform daily maintenance

Bolt, High strength bolts, Screw Warranty scope of milling machine 1. Clean the bed and its components, clean iron filings, and maintain a clean environment; 2. Check each oil level, not lower than...

Update June 10, 2023

What are the characteristics of tooth tapping machines

Bolt, High strength bolts, Screw 1. The spindle feed and retreat tool is automatically and precisely matched according to the tooth pitch, and will not float up during operation. 2. The operator's...

Update June 09, 2023

What are the usage scenarios for irregular steel pipes

Bolt, High strength bolts, Screw Specially shaped seamless steel pipes are widely used in various structural components, tools, and mechanical components. Compared with circular pipes, special-shaped...

Update June 08, 2023

Introduction and application scenarios of flower basket screws

Bolt, High strength bolts, Screw Flower basket screws, also known as flower basket screws, rigging, and tightening buckles, are used to bind and tighten steel wire ropes. Flower basket screws are...