Common problems with laser marking machine computers and what to do if the XY axis is not on time

2023-06-17 15:46:00

The complexity of the graphics during the processing must be checked.

The online computer cannot be connected to the network cable. It can control the laser system independently.

Slow operation, please do not be too impatient at this time to avoid crashing.

Please pay attention to preventing viruses and system errors.

The XY axis of the workbench is not on time

Are the screws on the workbench slide loose?

The glass on the workbench is determined according to the customer's requirements, and can be replaced with iron or organic glass plates. The balance can be adjusted under the glass.

The electronic ruler can be installed on the right and upper and lower corners of the workbench, making it easy for customers to meet their needs.

The screw holes on the workbench can facilitate customer positioning and use, which is denied by the product.Common problems with laser marking machine computers and what to do if the XY axis is not on timeCommon problems with laser marking machine computers and what to do if the XY axis is not on time