What should I do if I encounter a situation where the laser marking machine cannot cut through

2023-06-15 15:42:34

There are various reasons for problems, and the following are some troubleshooting methods:

If the vertical light is not correct, it is necessary to adjust the vertical light. If necessary, the light path can be readjusted.

If the focal length is not adjusted properly, it needs to be readjusted.

When the voltage is unstable or too low, it is necessary to replace a larger voltage regulator to increase the output of laser current.

If the outlet of the air nozzle is blocked by splashed material, it is necessary to clean the air nozzle.

5. Protective gas cannot circulate - it is necessary to clean the air pump, air filter, and check the airflow circulation path.

6. It is necessary to clean the reflector and focusing lens because they have already been contaminated. An appropriate amount of cleaning solution can be used to clean the reflector and focusing lens.

If the power of the laser tube decreases, a new laser tube needs to be replaced.

8. The motherboard needs to be replaced because the light control module on the motherboard has malfunctioned.

9. If there is a problem with the Potentiometer equipment, such as improper setting or failure of the Potentiometer, adjust it or replace the Potentiometer.

The energy setting in the software is too small, and it needs to be increased.

11. Material Selection - Please select the appropriate material

When the focusing lens cracks or the focusing effect deteriorates, a new focusing lens needs to be replaced.

If there is too much dirt inside the laser tube, its heat dissipation effect will deteriorate. At this point, you can choose to use purified water for cleaning.